Текст страницы
LCD while adjusting gain. Try to adjust gain as
high as possible without clipping, which is
indicated by the red rectangle at the top of the
meter.
Combo jack summary
Use these guidelines for 48V phantom power and
trim settings on the two combo input jacks:
Input
48V
Trim
Condenser mic
On
As needed
Dynamic mic
Off
As needed
Guitar
Off
As needed
Line level
Off
Zero
A/B monitor switching on the M6
If you have an M6 and two different sets of studio
monitors, and you would like to be able to switch
between them to compare how your mixes sound
on each pair, connect your primary monitors (A)
to the MONITOR 1-2 outputs and connect the
secondary monitor pair (B) to LINE OUT 1-2.
Then press and hold the A/B switch on the front
panel. Doing so engages A/B mode. In this mode,
you can then quickly press the A/B button to
switch between the A speakers and B speakers.
More specifically, in A/B mode, LINE OUT 1-2 no
longer function as independent outputs. instead,
they mirror the signal on the MONITOR 1-2
outputs, and the A/B switch controls which pair
plays (while the other is muted).
To exit A/B mode, press and hold the A/B switch.
TRS quarter-inch analog inputs and outputs
Quarter-inch analog inputs and outputs are
balanced (TRS) connectors that can also accept an
unbalanced plug. The outputs are DC-coupled, so
they can be used for CV control output.
Quarter-inch analog outputs are not
cross-coupled. Therefore, when connecting them
to an unbalanced input, use a TRS plug with the
ring disconnected. Not floating the negative
terminal will short it to the sleeve ground and
cause distortion.
Headphones
Connect your headphones to the headphone
output on the front panel. The headphone output
mirrors the signal on the MONITOR 1-2 outputs.
Use the volume knob above it to control its volume
independently. The M6 has two headphone
outputs. Both mirror the signal on the MONITOR
1-2 outputs and have their own independent
volume control. One of the headphone outputs has
a 3-4 switch. When engaged, the output mirrors
the signal on LINE OUT 3-4 instead. This allows
you to set up a separate headphone mix from your
host software (on outputs 3-4).
Unbalanced RCA outputs (M2 and M4 only)
Connect the unbalanced RCA outputs to other
gear that has similar unbalanced RCA inputs, such
as DJ systems, karaoke equipment or consumer
audio devices.
Monitor outs
In a standard studio configuration, the monitor
outs are intended for a pair of primary studio
monitors, but they can be used as regular outputs
for any purpose.
H A R D W A R E I N S T A L L A T I O N
19