Текст страницы
EN
INSTALLATION INSTRUCTIONS
The appliance must be installed and commissioned by a qualified technician in accordance with
established regulations and local health and safety regulations..
1. Open the four screws located on the top and bottom of the device and remove the cover
from base.
2. Fix the base horizontally against a wall or side of cabinet, ground wire must be connected
to the unit, the inlet and outlet water pipes are on the down/bottom side of the unit. Use 4
mounting screws provided.
N
G
L
AURES
SLIM MULTI
3. Use the supplied water filter on the inlet water pipe line (see page 9).
4. Connect the incoming water line (cold only) to the inlet water pipe on the bottom left side and
the outgoing water line to the outlet water pipe on the bottom right side. Open the mains cock
of water supply and check there is no water leakage from the unit.
5. Before performing any operations, disconnect the appliance from the electricity mains using
the external switch then connect the power to cable to the appliance. The appliance must be
earthed and the earth cable (show with a letter in the drawing) is fixed to the terminal marked
by the symbol
.
6. Turn on the unit and check that it is operating as required.
7. Reconnect the cover to the base with 4 screws.
8. It is required that a Ground Fault Circuit Interrupter/Earth Leakage Circuit Breaker be
incorporated in the circuit.
9. Make sure to install in the right way the pressure relief valve (supplied with the
product) before Inlet pipe.
10. It is required to install a flow control restrictor (AERATOR) at the sink or shower.
5