Текст страницы
Reduction of environmental impact
Information on reducing the environmental impact from cooking and non-destructive
disassembly.
The following calculation and measurement methods were used to determine the results and
in accordance with the requirements for labeling in terms of energy consumption and in terms
of ecodesign requirements: Directives of the European Parliament and of the Council -
Regulation (EU) No. 65/2014 and No. 66/2014.
EN 50564:2011 - Electrical and electronic household and office equipment - Measurement of low
power consumption.
Information on reducing the environmental impact (e.g. energy consumption) from cooking in
accordance with Annex I, No. 2 of Regulation (EU) No. 66/2014 with a regard to setting
ecodesign requirements for household ovens, hobs and cooker hoods.
•
Use baking pans and trays with dark and matte surfaces, because they conduct heat better
•
Open the oven door during cooking only when necessary
•
Preheat the cooking chamber only when necessary according to the recipe
•
Always select the lowest recommended temperature for cooking temperatures
•
Switch the oven to minimum temperature shortly before the end of the cooking time to use the
residual heat
•
To ensure energy efficiency, switch all buttons (temperature, interior light and program) to
"0/Off" when the oven is not in use
•
Remove any soiling immediately, otherwise the cleaning effort may increase
•
Use biological cleaners to clean the oven
Information for professional users for dismantling according to Annex I, No. 2 of Regulation
(EU) No. 66/2014
Information on non-destructive disassembly for maintenance purposes
•
Disassembly for maintenance purposes can only be performed for the oven door (see chapter
"Disassembling the oven door" p.71).
•
Disassembly for maintenance purposes is not foreseen.
•
For repair and replacement of defective parts, please contact the customer service.
•
Accumulators are not included.
Disassembly information related to recycling, recovery and disposal at the end of the life of the
device.
•
Dismantling of devices with gas connection may only be carried out by a licensed gas and
water installer.
•
Dismantling of devices with electrical connection should be performed by a licensed electrician.
For recycling and resource recovery, specify the device:
•
municipal collection point run by the public waste disposal authorities
•
manufacturer's own waste disposal company that offers a take-back system
•
local electrical retailer who voluntarily takes back electrical equipment.
For information on the energy efficiency index for each oven compartment, the dimensions of
the appliance, the number of oven compartments, the heat source per oven compartment and
the volume per oven compartment please refer to the data sheet, attached to the user manual.