Текст страницы
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS
POSSIBLE CAUSES
POSSIBLE SOLUTION
Check fuse or breaker.
Fuse blown or breaker
tripped.
Tool will not start.
Extension cord not plugged
in.
Check to make sure extension
cord is plugged into a
working outlet.
Chain too tight.
Refer to Adjusting the
chain tension section.
Bar/chain overheated.
Lubrication needed.
Refer to LUBRICATION
section.
Chain is loose.
Chain tension set incorrectly.
Refer to Adjusting the
chain tension section.
Chain tension set incorrectly.
Poor cut quality.
Refer to Adjusting the
chain tension section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
Chain needs replacement.
Refer to sections for
CHANGING THE GUIDE
BAR AND CHAIN.
20
Unit runs but does not cut.
Chain installed backwards.
See Fig H and illustration.
Refer to CHANGING THE
GUIDE BAR AND CHAIN
section.
ENVIRONMENTAL PROTECTION
This product has been marked with a symbol relating to removing electric and electronic
waste. This means that this product shall not be discarded with household waste but that it
shall be returned to a collection system which conforms to the European Directive 2002/96/
CE. It will then be recycled or dismantled in order to reduce the impact on the environment.
Electric and electronic equipment can be hazardous for the environment and for human health
since they contain hazardous substances.