Текст страницы
8
9
en
en
STORAGE
RECYCLING
• Let the unit cool down for 5-10 minutes and switch it
on again. Do not block the air inlets during the unit
operation and avoid getting of hair into the air inlets
(6).
The manufacturing date is specified in the serial
number.
In case of any malfunctions apply to an authorized
service center.
CLEANING AND MAINTENANCE
• Disconnect the unit from the mains and clean it.
• Do not wind the power cord around the hot air styler,
as this can damage the cord or the unit body.
• For easy storing there is a hanging loop (7), you can
hang the hot air styler on this loop provided that no
water gets on the unit in this position.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
DELIVERY SET
To prevent possible damage to the
environment or harm to the health of
people by uncontrolled waste disposal,
after service life expiration of the unit or the
batteries (if included), do not discard them
with usual household waste, deliver the unit and the
batteries to specialized centers for further recycling.
The waste generated during the disposal of the unit
is subject to mandatory collection and consequent
disposal in the prescribed manner.
For further information about recycling of this product
apply to a local municipal administration, a disposal
service or to the shop where you purchased this
product.
1.
Hot air styler — 1 pc.
2.
Concentrator nozzle — 1 pc.
3.
Thermo brush 38 mm in diameter — 1 pc.
4.
Flat brush — 1 pc.
5.
Instruction manual — 1 pc.
TECHNICAL SPECIFICATIONS
• The hot air styler is intended for household use only.
• Set the switch (5) to the position «0» and unplug the
unit, wait until the installed thermo brush (8, 10) cools
down completely.
• Remove the installed attachment (2, 8, 9, 10). To
do this, press on the locks (1) simultaneously and
remove the attachment.
• Wipe the unit body with a slightly damp cloth, and
then wipe it dry.
• Clean the air inlets (7) with a brush.
• Do not immerse the unit into water or any other
liquids.
• Do not use abrasives and solvents to clean the unit
body and the attachments (2, 8, 9, 10).
The manufacturer reserves the right to change the
design, structure and specifications not affecting
general principles of the unit operation, without prior
notice.
- Supply voltage: 220-240 V, ~50-60 Hz
- Rated input power: 1200 W
The unit operating life is 3 years
ATTENTION!
Do not allow children to play with
polyethylene bags or packaging film.
Danger of suffocation!