Текст страницы
7. Release Film (FEP) Replacement
1
2
Parameters
Recycle the resin in the resin vat back into the
original bottle , then clean up. (Note: Please make
sure there are no residue matter left inside the Vat)
Remove all the screws at the bottom of the resin vat, take
out the fixing plate and the release film. (Note: The fixing
plate andthe vat bottom need to be cleaned)
Size：286*198mm
4
3
Thickness：0.15-0.2mm
Gently remove the protective film on
the front and back of the release film.
Align the release film positioning holes
with the fixing plate positioning posts.
5
6
×
Light Transmittance
95%
Make sure the release film is flat and tight after installation.
(Note: If not flat or loose, please check whether the screws
are locked or the release film is abnormal)
Press into the bottom of the vat, and tighten the
screws diagonally across from each other one at
a time. (Note: Make sure there are no debris
between the fixing plate and release film)
Tips: ① The diagram is a reference for the film change procedure, please refer to the physical product; if there are excess edges after installation
of the release film, you will need to cut them off.
② It is recommended to replace the release film when it has been used for more than 200 hours.
01
10