Disassembly and Assembly
4 Insert the key rubber into the fingerprint sus following the sus shape.
5 Prepare the CIPG adhesive (DY-163). Open the both end caps of the CIPG adhesive
and assemble with the needle and piston one by one. Before using the adhesive for
the first time, apply it to tissue or paper for about 3 seconds and discard the first
part of the adhesive. Inject the adhesive on the fingerprint bracket. Connect the
fingerprint connector and then connect the battery connector.
• Before using the adhesive, you must wear protective safety equipments such as glasses, gloves, and a mask for your safety.
• If the adhesive is in contact with the skin, wash it off with clean water immediately.
• Adhesive is not allowed to be used for other purposes.
• Be careful not to get stabbed or injured by needle.
• If the applied adhesives overflows, wipe it carefully with a clean and soft cloth.
• Be careful not to overturn the device or cause external impact for at least 90 minutes while drying the adhesive.
The actual adhesive, piston, and needle may be different from the image.
155
