Текст страницы
• Only apply the tool to the fastener when the tool is switched off. Rotating bits
can slip off and damage the fastener head.
• It is recommended to perform the first few turns manually by hand, key, or a
screwdriver to ensure the correct driving of a fastener.
• In case of working with threaded components, do not exert too much pressure
on the tool. This can lead to the damage of the thread.
• Always hold the tool bit perpendicularly aligned with the fastener (Fig. 9).
Holding it at an angle may cause slipping or jamming of the fastener.
Fig. 9
Driving and Removing Screws
(Fig. 9)
1. Select and install a suitable bit.
2. Adjust the pivot head to a desired
angle.
3. Unlock the tool by pressing the lock-
off button until the lock-off indicator
goes off.
4. Apply just enough pressure to keep
the bit engaged on the screw.
5. Press the front half of the forward/
reverse switch to drive screws in. Press the rear half of the forward/reverse
switch to remove/loosen screws.
6. If the tool stops before a screw is completely driven in, increase the torque
setting (see chapter “Setting the Torque”) or finish driving the screw
manually (see chapter “ Automatic Spindle Lock”).
Automatic Spindle Lock
The automatic spindle lock allows you to use the screwdriver as a manual
screwdriver. You can give an extra twist to firmly tighten a screw, loosen a very
tight screw, or continue working when the battery charge is depleted.
14