Текст страницы
3 Installation
(Varies depending on the product
model.)
C
On some hob burners, the injector
is covered with a metal piece. This
metal cover must be removed for in
jector replacement.
1. Flow rate adjustment screw
1. Flame failure device (model dependant)
2. Spark plug
3. Injector
4. Burner
1. Flow rate adjustment screw
C
C
Unless there is an abnormal condi
tion, do not attempt to remove the
gas burner taps. You must call an
Authorised service agent or techni
cian with licence if it is necessary to
change the taps.
Reduced gas flow rate setting for hob taps
1. Ignite the burner that is to be adjusted and turn
the knob to the reduced position.
If the gas type of the unit is changed,
then the rating plate that shows the
gas type of the unit must also be
changed.
Leakage check at the injectors
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust
Before carrying out the conversion on the product,
ensure all control knobs are turned to off position.
After the correct conversion of injectors, for each
injectors should be gas leak checked.
1. Make sure that the gas supply to the product is
the flow rate adjustment screw.
For LPG (Butane - Propane) turn the screw clock
wise. For the natural gas, you should turn the screw
counter-clockwiseonce.
on, still maintaining all control knobs turned to
off position.
» The normal length of a straight flame in the re
duced position should be 6-7 mm.
2. Each injector hole is blocked with a finger ap
4. If the flame is higher than the desired position,
turn the screw clockwise. If it is smaller turn an
ticlockwise.
plying reasonable force to stop the gas leakage
when corresponding control knob turned to on
and it held at depressed position to allow gas
reach the injector.
5. For the last control, bring the burner both to
3. Apply prepared soapy water at the injector con
high-flame and reduced positions and check
whether the flame is on or off.
Depending on the type of gas tap used in your ap
pliance the adjustment screw position may vary.
nection with a small brush, if there is leakage of
gas at the injector connection the soapy water
will begin to froth. In this case, tighten the in
jector with a reasonable force and repeat step 3
process once again.
20 / EN
Built-in Hob / User Manual