Текст страницы
11
EN
Caution! When operating the unit, use only the
pusher (6) supplied with the unit; do not use any
other objects. Never push the food with your hands!
• Place the bowl (17) on a flat and stable surface.
• Install the shaft (16) on the axis in the center of the
bowl (17).
Notes:
• To operate in maximum speed mode, press and hold
the «TURBO» button (3).
• During operation, place food into the feeding chute
(8) and feed it using the pusher (6).
• Monitor the filling of the bowl (17), do not allow the
bowl (17) overflowing.
• Release the button (3 or 4) to switch off.
• After using the unit, wait till the disc (12) fully stops.
• Remove the power plug from the mains socket.
• Disconnect the motor unit from the reducer lid (9) by
pressing the lock buttons (2) (Fig. 2).
• Remove the reducer lid (9) from the bowl (17) by
turning it counterclockwise.
• Remove the disc (12) from the bowl (17), holding the
top of the shaft (16).
• Take the chopped products out of the bowl (17).
CHOPPING
The time of continuous operation with the disc for
chopping (13) should not exceed 30 seconds. Take
a break of at least 3 minutes between two operation
cycles.
Before assembling make sure that the power plug is
not inserted into the mains socket.
-
Wash and prepare fruit or vegetables before
chopping. Cut the fruit so that it fits freely into the
feeding chute (8), remove the core or seeds.
-
Peel the vegetables from hard skins.
-
the disc for chopping (13) is double-sided; before
installing the disc (13), decide which side of the
disc (13) you need;
-
use the side of the disc (13) with a fine chopper for
chopping hard cheeses, first cut the cheese into
cubes of 25x25x25 mm.
• Install the disc for chopping (13) onto the shaft (16).
• Place the reducer lid (9) onto the bowl (17) and turn it
clockwise until it stops.
• Press the locks (2) and install the motor unit in the
installation location (7), make sure that the motor unit
is securely fixed. Install the motor unit vertically and
without distortion (Fig. 4).
• Insert the power plug into the mains socket.
• To switch on, press and hold down the «
» button
(4).
• When pressing and holding the «
» button (4), you
can adjust the rotation speed of the disk (12) by
turning the knob (5).
• To operate in maximum speed mode, press and hold
the «TURBO» button (3).
• During operation, place food into the feeding chute
(8) and feed it using the pusher (6).