Текст страницы
10
EN
STORAGE
It is normal
A sound of boiling
water inside the
garment steamer
and slight vibration
of the garment
steamer body
Boiling of water in
the steam chamber
is accompanied with
a corresponding
sound. The water
pump operation is
accompanied with
slight vibration.
• Unplug the garment steamer and wait till it cools
down completely.
• Clean the garment steamer.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
Troubles and troubleshooting
DELIVERY SET
Malfunction
Possible reason
Solution
1.
Garment steamer – 1 pc.
2.
Brush attachment – 1 pc.
3.
Manual – 1 pc.
- Insert the power plug
into the mains socket
Small amount or
absence of outgoing
steam
- The garment
steamer is not
connected to the
socket
TECHNICAL SPECIFICATIONS
- There is not enough
water in the tank
- Unplug the unit, remove
the water tank and fill it
with water, then install
the water tank back to
its place
- The water tank is
not installed correctly
- Power supply: 220-240 V, ~ 50/60 Hz
- Rated input power: 1370-1630 W
- Water tank capacity: 270 ml
- Steam release: 18-26 g/min
- Make sure that the
water tank is installed
properly
RECYCLING
The garment steamer
is not hot enough
Let the garment steamer
heat up a little longer
before the use
When the steam
supply is switched
on, water leaks from
the steam release
openings
It is normal
Water leaks from
the steam release
openings
To prevent possible damage to the
environment or harm to the health of
people by uncontrolled waste disposal,
after expiration of the service life of the
unit or the batteries (if included), do not
discard them with usual household waste,
take the unit and the batteries to specialized stations for
further recycling.
During heating the
pressure in the steam
chamber increases
and water drops can
appear in the steam
release openings