Текст страницы
8
EN
ATTENTION! Before detaching the water tank (1),
make sure that the power plug (9) is not inserted
into the mains socket.
• Press the buttons (3) and remove the water tank (1)
(pic. 1).
• Open the water inlet lid (2). Fill the water tank (1) with
water non exceeding the MAX mark and close the
water inlet lid (2) tightly (pic. 1).
• Do not fill the tank (1) with carbonated water,
perfume additives, vinegar, chemical agents, etc.
• Install the water tank (1) back to its place and make
sure that the tank (1) is fixed properly.
ATTENTION!
• Before general use of the garment steamer clean the
steam chamber. To do this, direct the outgoing steam
to a piece of cloth, for instance, try to smooth out a
kitchen towel.
• If during the operation the water tank (1) becomes
empty, before removing the tank (1) and refilling
it with water switch the garment steamer off by
pressing the on/off button (8), disconnect the power
plug (9) from the mains socket.
• After the unit operation switch the garment steamer
off and remove the power plug (9) from the mains
socket and let the garment steamer cool down.
Note: when switching the unit on for the first time,
foreign smell can appear. It is normal.
USING THE BRUSH ATTACHMENT
Do not plug the garment steamer in if the water tank
(1) is empty.
ATTENTION!
Before installing the brush attachment (11) and
removing the tank (1), make sure that the power
plug (9) is not inserted into the mains socket.
• Place the garment steamer on the base (10) on a flat
and steady surface.
• Connect the power plug (9) to the mains socket, to
switch the garment steamer on, press the button (8),
the button (8) indicator will light up. Wait for some
time (from 30 to 35 seconds) necessary for normal
generation of steam.
• Take the garment steamer by the handle (7) on the
same level with the steam supply on button (4) (pic.
3).
• To switch the steam supply on, press and hold down
the button (4).
• To switch the steam supply off release the button (4).
• Install the brush attachment (11) on the garment
steamer (pic. 2).
• Press the buttons (3) and remove the water tank (1)
(pic. 1).
• Open the water inlet lid (2). Fill the water tank (1) with
water non exceeding the MAX mark and close the
water inlet lid (2) tightly (pic. 1).
• Do not fill the tank (1) with carbonated water,