Текст страницы
8
EN
Remote control (23)
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to
play with the battery. If your child has swallowed
a battery, immediately see a doctor. Battery
installation/replacing (pic. 3)
• Press on the clamp and remove the battery holder
(21) from the remote
• control (22) body, insert a CR2025 battery (supplied
with the unit) into the holder, strictly following the
polarity.
• Install the battery holder (21) into the remote control
(22).
Notes:
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
ASSEMBLING THE FAN
-
if there is an isolation insert in the battery holder
(21), remove the insert;
-
replace the battery in time;
-
do not recharge the lithium battery;
-
remove the battery if you are not planning to use
the unit for a long time;
-
remove the used battery from the remote control
(22) and dispose of it.
• When you use the remote control, direct it to the front
part of the fan body (2).
• The distance between the remote control and the fan
should not exceed 5 m, the coverage angle should
be up to 30 degrees.
• The fan is delivered with a disassembled base (1).
Do not switch the fan on without the base (1).
• Use a crosshead or flat tip screwdriver (not supplied)
to assemble the base (1).
• Position the fan body (2) horizontally.
• Assemble the Base (1): join the two halves of the
Base (1) (fig. 1) and secure them using 4 screws.
• Using the 4 screws, attach the Base (1) to the lower
part of the body (2) (fig. 2).
• Place the fan vertically on the base (1).