Текст страницы
Mounting
Very heavy product; hood handling and installation must be carried out by at least two persons.
Before beginning installation:
Check that the product purchased is of a suitable size for the chosen installation area.
Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws (*), guarantees (*), etc.),
eventually removing them and keeping them.
If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall/ceiling.
for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it.
In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket
is available and it is possible to connect a fumes discharge device to the outside (only suction version).
Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube).
of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not
tile, grout or silicone this appliance to the wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapors. It is recommended that the cooker hood suction is switched on for
5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Touch controls
Delay-off
Fan Minus
Fan plus
Light
Display window
wake-up switch
Touch , the other four buttons are activated and lighted.
1. Delay-off :
The delay button can only be clicked when the hood is running.
When the hood is running, touch , the “9” in the window lights up and flashes for 3 seconds. Touch and to set delay time from
0 to 9 minutes. After delay-off, the hood returns to the standby mode automatically.
2. Adjust speed
Touch for one time, the speed is displayed as “1”,. Continue to touch, the speed will cycle as speed 0-1-2-3-4.
Touch for one time, the speed is displayed as “4”,. Continue to touch, the speed will cycle as speed 4-3-2-1-0.
3. Light
Touch to turn on or off the light.
08