Текст страницы
Routine Maintenance
EN EN Routine Maintenance
4. Remove the filter and tap its basket gently.
Clean the Dust Bin and Filter
Clean the Mopping Module
1. Open the robot cover and press the bin clip to remove the dust bin.
Parts
To keep the robot in good condition, it is recommended to refer to the
following table for routine maintenance.
1. Slide the two release clips on the side of water tank to remove
the mopping module, and then pull the mop pad off the mopping
module.
Part
Maintenance
Frequency
Replacement Period
Mop pad
After each use
Every 3 to 6 months
Main brush
Every 6 to 12 months
Dust bin filter
Once every 2 weeks
Every 3 to 6 months
Side brush
Note: Do not attempt to clean the filter with a brush, finger, or any sharp objects so as to
avoid damaging it.
2. Open the bin cover and empty the bin as shown in the diagram.
Auto-empty base's
signaling area
Charging contacts
Auto-empty vent
5. Rinse the dust bin and filter with water and dry them completely
before reinstalling.
Universal wheel
Once every month
/
12
1
11
2
10
Laser Distance
Sensor (LDS)
2. Pour out the water in the tank. Clean with water only and leave
to air dry before re-installing.
3
9
24 hrs
4
8
5
7
6
AI visual sensor
Cliff sensors
3. Clean the auto-empty vent.
Water tank
Clean it as needed
/
Dust bin
Dust collection bag
/
8-10 weeks
Note:
Note: Do not directly expose the water tank to sunlight.
Note: The replacement frequency will depend on your usage of the robot. If an exception
occurs due to special circumstances, the parts should be replaced.
· Rinse the dust bin and filter with clean water only. Do not use any detergent.
· Use the dust bin and filter only when they are completely dry.
14
15