Текст страницы
How to Use
How to Use
EN
EN
2) Fill the tank with water.
1. Fast Mapping
4. Pause/Sleep
7. Scheduled Cleaning
You can schedule cleaning time in the Dreamehome app. The robot
will automatically start cleaning at the designated time and then
return to the base to recharge when the cleaning is done.
When the robot is running, press any button to pause it. If the
robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off. Press any
button on the robot, or use the app to wake up the robot.
After configuring the network for the first time, follow the
instructions on the app to quickly create a map. The robot will
start mapping without cleaning. When the robot returns to the
base, the mapping process has been completed and the map will
be saved automatically.
Note:
8. Additional App Functions
2. Turn On/Of
· The robot will turn off automatically if left in Sleep Mode for more than 12 hours.
· If the robot is paused and placed onto the base, the current cleaning task will end.
Follow the instructions on the app interface to use more functions.
The version of the app might have been updated. Please follow
the instructions based on the current app version.
5. Do Not Disturb (DND) Mode
9. Use the Mopping Function
Note:
Press and hold the
button for 3 seconds to turn on the robot.
The power indicator should be illuminated. Place the robot onto
the base. The robot should turn on automatically and begin
charging. To turn off the robot, move the robot away from the
base and press and hold the
button for 3 seconds.
· Do not use detergent or disinfectant.
· Do not fill the water tank with hot water as this may cause the water tank to warp.
It is recommended that all floors are vacuumed at least three
times before the first mopping session to achieve a better cleaning
effect.
3. Start Cleaning
When the robot is set to the Do Not Disturb (DND) mode, the robot
will be prevented from resuming cleaning and the power indicator
goes out. The DND mode is disabled by default at the factory.
You can use the app to enable the DND mode or modify the DND
period. The DND period is 22:00-8:00 by default.
Note:
3) Align the mopping module as indicated by the arrow, then
slide it into the back of the robot until it clicks into place. Press the
button
or use the Dreamehome app to start cleaning.
1) Dampen the mop pad and wring out excess water. Install the
mop pad as shown in the diagram.
Press the button
briefly to start cleaning after the robot is
turned on. The robot will accurately map out a route, methodically
clean along the edges and walls, then finish by cleaning each
room in an S-shaped pattern to ensure a thorough job.
· The scheduled cleaning tasks will be performed on time during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
6. Spot Cleaning
Click
When the robot is on standby, press briefly the
button to enable
the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5 × 1.5 meters around it and returns to its starting
point once the spot cleaning is completed.
Click
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the water flow as required.
12
13