Текст страницы
NOTE:
The epilator nozzle is equipped with a backlight for more detailed skin treatment
Cleaning (only when the appliance is switched off)
After using the device, turn it off and clean the epilator nozzle by removing the protection cap. Clean the
nozzle tweezers with the supplied brush by turning them manually. Remove the nozzle from the body of the
device and tap it lightly to remove any remaining hair.
If the contamination of the hair is strong, the device, with the nozzle installed, can be rinsed under a stream
of hot water. After rinsing, disconnect the nozzle and let it dry.
Shaving head
The shaving head is designed for shaving the legs, armpits and bikini area. For best results, perform the
shaving procedure on dry skin. To trim the hairs to a length of 3 mm, attach a comb attachment and guide it
horizontally along the surface of the skin, with holes against the direction of hair growth.
Cleaning (only when the appliance is switched off)
Do not clean the shaving head with a brush, as this may damage the mesh. The shaving head can be rinsed
under running water. Remove the shaving unit and dry the appliance. Regular lubrication of parts (mesh +
trimmers) is required.
After cleaning, apply a little oil from the oiler to the edge of the knife blade, activate the blades for a while,
turn off, then wipe off the protruding excess oil. This procedure helps the blades maintain sharpness, rotate
easily and prevents wear.
Trim head
You can use the trimmer head to trim bikini parts and hard to reach places;
Please place the trim head flat on the skin for trimming and place the trim head perpendicular to
the skin for modeling and trimming
You can install the comb on the tip to trim the hair from the bikini to the desired length
Cleaning: (only when the device is switched off)
Clean the trimmer blades after each use with the included brush. Also, it is necessary to regularly lubricate
the blades of the trimmer nozzle with the oiler from the supplied kit to increase its service life. After
lubrication, it is recommended to turn on the machine for a while to remove excess oil.
After cleaning, apply a little oil from the oiler to the edge of the knife blade, activate the blades for a while,
turn off, then wipe off the protruding excess oil. This procedure helps the blades maintain sharpness, rotate
easily and prevents wear.
16