Текст страницы
Rack Installation
About This Guide
The switch can be mounted in an EIA standard size
19-inch rack, which can be placed in a wiring closet
with other equipment.
This guide gives step-by-step instructions for setting up
the DGS-1210-10MP switch. Please note that the model
you have purchased may appear slightly different from
those shown in the illustrations.
1. Attach the mounting brackets to the switch's side
panels (one on each side) and secure them with the
screws provided.
Step 1 – Unpacking
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located in the
User Guide to make sure all items are present and
undamaged. If any item is missing or damaged, please
contact your local D-Link reseller for replacement.
• DGS-1210-10MP switch
2. Use the screws provided with the equipment rack to
mount the switch in the rack.
• Rack mounting brackets
Mounting kit and rubber feet
•
Power cord
•
Power cord retainer
•
Quick Installation Guide
•
Step 2 – Switch Installation
ENGLISH
For safe switch installation and operation, it is
recommended that you:
Grounding the Switch
• Visually inspect the power cord to see that it is
secured fully to the AC power connector.
This section describes how to connect the switch
to the ground. You must complete this procedure
before powering on your switch.
• Make sure that there is proper heat dissipation and
adequate ventilation around the switch.
Required tools and equipment:
• Don't place heavy objects on the switch.
• One M4 x 6 mm (metric) pan-head screw
(included in the mounting kit).
Desktop or Shelf Installation
When installing the switch on a desktop or shelf, the
rubber feet included with the device must be attached
on the bottom at each corner of the device's base.
Allow enough ventilation space between the device
and the objects around it.
• Grounding cable (not included in the mouting kit):
The grounding cable should be sized according to
local and national installation requirements.
Depending on the power supply and system, a 12
to 6 AWG copper conductor is required for
installation. Commercially available 6 AWG wire is
recommended. The length of the cable depends on
the proximity of the switch to proper grounding
facilities.
• A screwdriver (not included in the mounting kit).
2