Текст страницы
1. With the rough side facing down, insert the Tie Wrap
1. Verify if the system power is off.
into the hole below the power socket.
2. Place the terminal lug ring of the grounding
cable on top of the ground-screw opening,
insert the grounding screw into it and
tighten the screw with a screwdriver.
3. Attach the terminal lug ring at the other
end of the grounding cable to an
appropriate grounding stud or bolt on rack
where the switch is installed.
4. Verify if the connections at the ground
2. Plug the AC power cord into the power socket of the
Switch.
connector on the switch and the rack are
securely attached.
3. Slide the Retainer through the Tie Wrap until the end of
the cord.
Step 3 – Plugging in the
AC Power Cord
You can now connect the AC power cord into the rear of
the switch and to an electrical outlet (preferably one that
is grounded and surge protected).
4. Circle the tie of the Retainer around the power cord
and put it into the locker of the Retainer.
Power Failure
As a precaution, the switch should be unplugged in
case of power failure. When power is resumed, plug the
switch back in.
Installing Power Cord Retainer
To prevent accidental removal of the AC power cord, it is
recommended to install the power cord retainer together
with the power cord.
3