Текст страницы
ENG
GC-3050
Operation Manual
Fig. 5
Fig. 6
Fig. 7
7. CONNECTION AND INSTALLATION
• Connect the USB receiver q to an available USB port on
the computer.
• Download the software from the official site from the
product page and run the program «SVEN Gamepad.exe».
• In order to test and configure the gamepad, choose
«Control Panel» → «Devices and Printers», in the Windows
control panel (in the «XInput» mode, the gamepad is
displayed as «Xbox 360 Controller for Windows», in the
«DirectInput» - «PC / PS3 / PC360 / ANDROID»), then
right-click on the device icon and select. Gaming device
parameters (administrator rights may be required)
(Fig.5,6). The «Game devices» window will appear. In
XInput mode, the gamepad is displayed as «Controller
(XBOX 360 For Windows)» (Fig. 7), in the «DirectInput»
mode - «USB Vibration Joystick (BM)» (Fig.8). To switch
between the «DirectInput» and «XInput» modes, you must
press the HOME button for 6 seconds.
• To check and configure in «XInput» mode, select
«Properties» in the «Game devices» window, the
«Properties: Controller (XBOX 36 ...» window will pop-up
(Fig.9). In the «Verification» tab, you can check the
execution of commands when you press the buttons and
rotate the joystick. To calibrate the joystick, select the
«Settings»
tab,
click
«Calibrate»
and
follow
the
instructions.
• To check and configure in DirectInput mode, select
Properties in the Game Devices window, and the
Properties: USB Vibration Joystick (BM) window pops up.
In the «Test» tab, you can check the execution of
commands when you press the buttons and rotate the
joysticks, and also check whether the joystick is
connected to the PC in the «Connected State» line
(Fig.10).
In the «Calibration» tab, you can center the position of
both joysticks (Fig. 10). To do this, you need to set them to
the middle position, then click «Default» and «Set». After
calibration, you must click «Accept» or «OK» on the
bottom line of this window to save the changes.
Fig. 8
17