Текст страницы
M.2 EZ-Latch Click
M.2 EZ-Latch Plus
M2A_CPU
80
110
•• Installing the M.2 thermal pad (applicable only for M.2 connectors with pre-installed thermal pads):
When using a single-sided M.2 SSD, first attach the bundled M.2 thermal pad to the pre-installed thermal
pad on the M.2 connector before installing the M.2 SSD.
Do not install the bundled M.2 thermal pad when using a double-
sided M.2 SSD.
Bundled M.2 Thermal Pad
Pre-installed M.2 Thermal Pad
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
M2A_CPU:
Step 1: Turn the M.2 EZ-Latch Click clip clockwise and remove the motherboard heatsink.
If you want install an M.2 SSD in the 110mm hole, remove the EZ-Latch Plus clip from the 80mm
hole first.
Step 2: Remove the protective film from the thermal pad on the M.2 connector. Insert the M.2 SSD into the
M.2 connector at an angle.
If you wish to replace the thermal pad, it is recommended to use one with a thickness of 1.25mm.
Step 3: Press down on the front end of the M.2 SSD and make sure the M.2 SSD is secured by the clip.
Remove the protective film from the bottom of the motherboard heatsink, and finally, turn the M.2
EZ-Latch Click clip clockwise and then install the heatsink back in place.
&
&
Please visit GIGABYTE's website for details on using M.2 EZ-Latch Click/M.2 EZ-Latch Plus.
M.2 SSD installation with M.2 EZ-Latch Click: https://www.gigabyte.com/WebPage/1048/M.2-EZ-Latch-Click.html
M.2 SSD installation with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/920/M2-latchplus.html
M.2 SSD removal with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/921/removeM2.html
* Motherboard heatsink design may vary by model.
- 26 -