Текст страницы
DAY TO DAY MAINTENANCE CONT.
4 Clean removed burr grinder with brush.
CLEANING THE CONICAL BURR GRINDER
CLEANING THE STEAM WAND
WATER FILTER REPLACEMENT
ENGLISH
Be sure that the machine is turned off and
unplugged before proceeding.
Over time, material can build up in the steam
wand.
1 Remove all beans from the bean hopper. See
Switching Out Beans for reference.
1 Remove the cap on the bottom of the
cleaning brush to access the needle.
2 Remove bean hopper by lifting handle and
turning to counterclockwise.
2 Use the needle to remove any material from
the steam wand tip.
5 Then, clean burr grinder attached to machine
with cleaning brush.
1 Remove new
filter from its
packaging and
soak for 5 mins.
2 Whilst filter is
soaking, remove
water reservoir
from machine
and remove filter
housing from
reservoir.
6 Be sure to clean the inside of the grinding
cradle as well. The grinder chute cover
removes for easy cleaning.
3 For a deeper clean, use the wrench in the
middle of the cleaning brush to remove the
steam wand tip.
4 Rinse new water
filter and mesh.
3 Remove used
water filter and
discard.
3 Remove upper burr by rotating
counterclockwise, aligning the orange arrow
on the burr grinder with the orange arrow
labeled ALIGN on the machine. Once aligned,
lift upper burr out.
NOTE: DO NOT allow burrs to come into
contact with water.
6 Set date 2 months
ahead.
4 Use the needle to remove any material from
inside the steam wand and steam wand tip.
NOTE: When cleaning the burr grinder attached
to the machine, only use the cleaning brush.
5 Remove end-cap
from filter housing
and insert filter.
Clip end-cap back
onto filter housing
to secure filter in
place.
7 Install filter housing
into reservoir.
5 After cleaning, run a purge to clear out any
excess material.
8 Fill reservoir with
water and return
to unit.
ninjakitchen.eu
87
ninjakitchen.eu
86