Текст страницы
GB
Cleaning the cup grill 7 and the water collection
container 8 :
Note: Empty the water collection container 8 peri-
odically
Remove the cup grill 7 and rinse it out under
running water
Remove the water collection container 8 , empty
it and rinse it out under running water
properly after some time Eecause hard water and very
calcareous water have primarily Eeen used, the lime-
scale must Ee removed to solve the proElem For this
purpose you should only use the Ariete descaling agent
NO&AL with a citric acid Ease
This product can Ee purchased easily at an Ariete cus-
tomer service centre Ariete accepts no liaEility for dam-
age to components of the Espresso machine from the
use of non-compliant products with chemical additives
Follow the instructions on the instruction decalcifying
agent leaÀet
Cleaning the surface of the machine
Shutting down
CAUTION!
Only clean the permanent components of the machine
with a damp cloth to avoid damage to the casing
Descaling
In case of shut down, you must detach the machine
from the power supply, empty the water tanN and the
collection container and clean the device (see the
chapter ³&leaning the device³ In case of scrapping,
you must taNe care to dispose of the different individual
parts according to the applicaEle laws of the country
in which the device is Eeing used
Good maintenance and regular cleaning protect the
device, ensure a longer lifespan and limit the Euild up
of limescale If the device still does not function
Troubleshooting
Problem
Cause
Solution
Not releasing steam
Too little water in the water tanN 18
the pump has no suction
&hecN whether the water tanN 18 has Eeen
inserted correctly and that there is enough
water in the water tanN 18 Fill the water
tanN 18 with fresh, still water up to the
³0A;³ marN
The opening of the steam pipe 17 is
ElocNed
Remove any ¿lm which has Euilt up at the
opening of the steam pipe 17 with a pin
Water Àows out of
the side of the ¿lter
holder 10
The ¿lter 13 is proEaEly too full, mean-
ing the ¿lter 13 cannot Ee properly
screwed into the frame
Remove the ¿lter holder 10 very slowly, Ee-
cause this may lead to residual pressure and
a spraying of water &lean the frame with a
small sponge Try it again with the correct
amount of coffee
There are Eits of ground coffee on the
seal of the coffee ¿lter frame
Try it again with the correct amount of coffee
The hole in the silicone perforated
disN 12 is ElocNed
Rinse out the silicone perforated disN 12 un-
der running water Turn it so that the middle
opening can Ee unElocNed Ey removing the
coffee powder that it stucN in it
20
1363_Espressomaschine_Content_IT_GB_FR_DE_ES_PT_NL_GR_RU_AE.indd 20
07.08.15 09:12