Текст страницы
PL
EN
4. The metal funnel and water tank should be washed after each use by rinsing them under water. To assist
in keeping the metal funnel clean, recommend you periodically run the machine with the metal funnel in
place, without coffee, using water only. Should the holes in the steel mesh become blocked with coffee
grinds, use a fine bristled brush to help clean. When your coffee maker is not being used, recommend that
you do not leave the metal funnel attached to the machine as this will reduce the life of the gasket.
5. Remove the removable cup shelf and drip tray from the appliance and remove any spilt coffee and water.
Then, clean them with a damp cloth or a damp sponge.
6. You must clean the steam wand and steam wand sleeve immediately after each use, after it has cooled
down. Place the steam wand in a jug or mug and use the steam setting to clear any remaining milk out of
the steam wand and steam wand sleeve. Remove the steam wand sleeve, place under warm running water
to remove excess milk. If the steam wand becomes blocked, use a small pin to clean more thoroughly.
WARNING: Steam from the steam wand is extremely hot and can scald.
Note:
Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning. Never wash
your coffee machine accessories in a dishwasher.
CLEANING MINERAL DEPOSITS (DESCALING)
1. Disconnect the appliance from the mains supply, cut off power source.
2. Make sure the appliance has cooled down completely.
3. Remove the water tank and drip tray from the appliance.
4. Fill water tank with water and dissolved descaler solution to the MAX level (the proportion of water
and descale, refer to the instruction of descaler). Please use “household descaler”, instead of industrial
descaler.
5. Re-fit the water tank and drip tray to the appliance.
6. Place an empty container under the brewing head to gather the descaled hot boiled water.
7. Connect the appliance to the mains supply.
8. Press the power button and wait for the 1 cup button, 2 cup button and manual button, to illuminate
solidly.
9. Place the steam wand into a mug or jug and slowly turn the steam control knob until water dispenses.
10. Keep dispensing to fill the mug or jug, then empty when full.
11. Repeat the process until the water tank is empty.
12. Immediately refill the water tank with clean water and repeat the process to flush the system.
16