Текст страницы
Version 1.0
(3) Click Apply.
2.
Set port priority.
(1) Click Port Management > Port Configuration.
(2) Select a port (port 1 and port 2 in this example) and set the Priority (High or Low).
(3) Click Apply.
----End
Tip
−
Priority for all ports should be set to Low when FIFO mode is used.
−
If the QoS mode is SP, set Port 1 to High and Port 2 to Low in Priority. When both ports send packets to
the same port at the same time, this port will let packets from Port 1 pass, followed by packets from
Port 2.
−
If WRR is selected, set weights to High=7 and Low=1 respectively. When both ports send packets to the
same port at the same time, this port will send packets in a traffic proportion of 7:1.
Chapter 9 Device management 32