Текст страницы
English
Installation
Desktop mounting
Paste the footpad (if any) to the recess on the bottom of the switch. Horizontally
place the switch right-side up on a big enough, clean, stable and flat desktop.
Wall mounting
Note
− The switch can only be installed on non-flammable walls, such as a concrete wall.
− Do NOT install the switch with air vents facing downward; otherwise, there will be potential
safety hazards.
Through wall-mounting slot
Use this method for switches with two wall-mounting slots on the bottom.
1. Use a hammer drill to drill 2 holes (diameter: 6 mm) on the wall and keep the
two holes on a horizontal line.
2. Knock the plastic anchors into the holes using a rubber hammer. Use a
screwdriver to fix the screws into the plastic anchors.
The distance between the inside surface of the screw header and the edge
of the plastic anchor should not be less than 2.5 mm, to make sure that the
switch can be hung on the screws firmly.
3. Align the two wall-mounting slots on the bottom of the switch with the two
screws on the wall, and then slide the switch to fit in the screws until it is
firmly hung on the screws.
Through L-shaped bracket
Use this method if two L-shaped brackets are provided.
1. Fix the two L-shaped brackets to both sides of the switch with the included
screws.
2. Place the switch horizontally onto the wall with its RJ45 ports facing upward,
and then mark the screw holes on the wall with a marker.
3. Drill holes in the marked positions, and then hammer the expansion bolts
(self-prepared) into the holes.
4. Insert the screws (self-prepared) through the holes of the two L-shaped
brackets, and secure the screws into the expansion bolts with a screwdriver.
Ensure that the switch is installed firmly with its RJ45 ports facing upward.
Rack mounting (to a standard 19-inch rack)
Use this method if two L-shaped brackets are provided.
1. Ensure that the rack is stable, level and properly grounded.
2. Fix the two L-shaped brackets to both sides of the switch with the included
screws.
3. Choose a proper height and fix the L-shaped brackets to the rack with
screws (self-prepared). Ensure that the switch is stable on the rack.
- 2 -