Текст страницы
ENG
Filtration System Installation Process
Figure 5.1.
Figure 5.2.
5. INSTALLING
THE FILTER ELEMENTS
- Install the new filter element by
inserting it into the filter head and
turning it clockwise 90° till you hear
a distinctive click and the triangular
markings match on the filter element
and its holder (Figure 5.1 and
Figure 5.2).
Figure 5.3.
Figure 5.4.
- Ensure that the triangular pointer at the
top of the filter element matches with
the same symbol on the filter element
holder (Figure 5.3).
- Install the filter elements from positions
1 to 3 from left to right (Figure 5.4).
Start of work with «BARRIER EXPERT»
Before using «BARRIER EXPERT»:
1. Check that the filtration system is properly connected in accordance with the diagram
on page 18 of this Manual.
2. Ensure that the ball valve is shut off.
3. Turn on the filtered water spigot.
4. Open the valve to the cold water main.
5. Open the ball valve. For a few minutes the filtration system will fill with water before it
comes out of the filtered water spigot.*
6. Using the ball valve, set the optimum water flow in accordance with the technical
characteristics of the filtration system.**
7. Turn off the filtered water spigot.
8. Ensure there are no leaks. If needed, tighten the connections and make sure that the
plastic tubes are properly installed in the fittings.
9. Turn on the filtered water spigot and flush 10 l of water through the system to rinse
the filter elements.
* The first few litres of filtered water may have a dark or cloudy appearance. It means that charcoal dust or air bubbles are being
rinsed out of the filter elements. The water filter operates correctly.
** During the service life of the filter elements, the flow rate of the filter may decrease. Restore optimum water flow by adjusting the
ball valve.
Attention!
During the first week of use, check the filtration system daily to find any
leaks. Tighten the connections as needed.
19