Текст страницы
ENG
BARRIER EXPERT System Installation
Before installation please read the instructions carefully
and study the filtration system connection diagram. Check
that all the required parts are present in the set. First,
decide where you are going to hang the filtration system
under the sink, as well as where you plan to install the
filtered water spigot to ensure maximum convenience in
daily use. The filtration system should be hung on the wall
using the screws leaving at least 1 cm of clearance below
the assembled system. Ensure that the filtration system
and the connecting plastic tubes do not come into contact
with hot water pipes.
At least 1 cm
Filtration System Installation Process
Attention!
Before beginning the installation of the water filter close the ball valve at the
cold water main inlet, and then open cold water cock of the mixing faucet, to
bleed pressure out of the pipe.
1. Installing the Spigot
- Choose a place to install the spigot
where it will be convenient to use it,
but which also leaves enough space
under the sink to fasten and connect
the spigot.
- Drill a hole 12 mm in diameter.
Figure 1.
Filtered
water spigot
- Install spigot. Tighten the nut
(See Figure 1).
Decorative
cover
- Screw on the straight fitting.
Rubber
washers
Sink
Plastic washer
Nut
Metal washer
Straight fitting
16