Текст страницы
ENG
Filtration System Installation Process
Figure 2.
2. INSTALLING THE ADAPTER
- Turn the ball valve on to the cold water
main. (Figure 2).
- Disconnect the kitchen mixing faucet
from the cold-water inlet tube.
- Screw the inlet tube onto the ball valve.
Ball valve
Figure 3.
3. PREPARE AREA FOR HANGING
Self-tapping screw attachment points
Template stickers
- Chose a place under the sink to hang
the filter. Bear in mind that the filter
needs to be connected to the ball valve
(water feed) and to the filtered water
spigot. For this the filter comes with two
plastic tubes, each 1 m long.
- Affix the template sticker to the chosen
spot for hanging the filter thus so the
height from the lower edge of the sticker
to the surface under the filter is at least
32 cm (Figure 3).
- Drive the self- tapping screws into the
points shown on the template.
At least 32 cm
17