Текст страницы
Cutouts
To tilt the base, loosen the bolt on the bottom of the base
with the hex wrench. Move the base so that the bolt is
positioned in the center of the bevel slot in the base.
Cutouts can be made with either of two methods:
“Boring a starting hole” or “Plunge cutting”.
3
Boring a starting hole
1
2
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm or more in diameter.
Insert the jig saw blade into this hole to start your cut.
Fig.18
► 1. Hex wrench 2. Bolt 3. Base
Tilt the base until the desired bevel angle is obtained. The
V-notch of the gear housing indicates the bevel angle by
graduations. Then tighten the bolt firmly to secure the base.
Fig.21
6
Plunge cutting
5
You need not bore a starting hole or make a lead-in cut
if you carefully do as follows.
1
3
4
2
Fig.19
► 1. Bevel slot 2. Base 3. Bolt 4. Graduations
5. V-notch 6. Gear housing
Fig.22
NOTE: When making bevel cuts with the dust
extraction, install the dust extraction on the opposite
side to the bevel. If the dust extraction is installed
on the same side to bevel, always reinstall the dust
extraction on the opposite side.
Front flush cuts
1.
Tilt the tool up on the front edge of the base with
the jig saw blade point positioned just above the work-
piece surface.
2.
Apply pressure to the tool so that the front edge of
the base will not move when you switch on the tool and
gently lower the back end of the tool slowly.
Loosen the bolt on the bottom of the base with the
hex wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
3
3.
As the jig saw blade pierces the workpiece, slowly
lower the base of the tool down onto the workpiece
surface.
4.
Complete the cut in the normal manner.
1
2
Fig.20
► 1. Hex wrench 2. Bolt 3. Base
12
ENGLISH