Текст страницы
Serial ATA3 Connectors
Right Angle:
These four SATA3
connectors support SATA
SATA3_3
SATA3_2
data cables for internal
storage devices with up to 6.0
Gb/s data transfer rate.
SATA3_0
SATA3_1
(SATA3_2:
see p.1, 2, No. 8) (Upper)
(SATA3_3:
see p.1, 2, No. 8) (Lower)
Vertical:
(SATA3_0:
see p.1, 2, No. 9)
(SATA3_1:
see p.1, 2, No. 10)
DUMMY
GND
GND
+A
+B
-A
-B
USB 2.0 Header
(9-pin USB_5_6)
(see p.1, 2, No. 7)
USB_PWR
USB_PWR
There is one header on this
motherboard. This USB
2.0 header can support two
ports.
1
Vbus
Vbus
Vbus
IntA_PB_SSRX-
IntA_PB_SSRX+
IntA_PA_SSRX-
GND
IntA_PA_SSRX+
IntA_PB_SSTX-
GND
USB 3.2 Gen1 Header
(19-pin USB3_3_4)
(see p.1, 2, No. 6)
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
There is one header on this
motherboard. This USB 3.2
Gen1 header can support
two ports.
IntA_PB_D-
GND
IntA_PA_D-
IntA_PB_D+
IntA_PA_D+
Dummy
1
GN D
OUT2_L
J_SENSE
OUT2_R
MIC_RET
PRESENCE#
MIC2_R
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, 2, No. 15)
This header is for connecting
audio devices to the front
audio panel.
MIC2_L
OUT_RET
1
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
English
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
18