Текст страницы
10) M2A_CPU/M2Q_SB/M2P_SB (M.2 Socket 3 Connectors)
The M.2 connectors on the motherboard support only M.2 PCIe SSDs.
M2A_CPU
80
110
M.2 EZ-Latch Click
M2Q_SB
M.2 EZ-Latch Plus
80
110
M2P_SB
80
110
M2A_CPU
M2Q_SB
M2P_SB
•• Installing the M.2 rubber pad:
a. When using a double-sided M.2 SSD, attach the thick rubber pad to the recommended placement
area as shown below.
b. When using a single-sided M.2 SSD, first stick the thin rubber pad to the thick rubber pad, and then
attach them to the recommended placement area as shown below.
Thin Rubber Pad (Gray)
Recommended Pad Placement
Area
Thick Rubber Pad (Black)
80
Avoid contacting any chips or IC components on the motherboard when attaching the rubber pads.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
•• M2A_CPU/M2Q_SB:
Step 1:
Turn the M.2 EZ-Latch Click clip clockwise and remove the motherboard heatsink.
If you want install an M.2 SSD in the 110mm hole, remove the EZ-Latch Plus clip from the
80mm hole first.
Step 2:
Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2 SSD
and make sure the M.2 SSD is secured by the clip.
Step 3:
Remove the protective film from the bottom of the motherboard heatsink, and finally, turn the M.2 EZ-
Latch Click clip clockwise and then install the heatsink back in place.
* Types of M.2 SSDs supported by each M.2 connector:
M.2 PCIe x4 SSD
M.2 PCIe x2 SSD
M.2 SATA SSD
M2A_CPU
a
a
r
M2Q_SB
a
a
r
M2P_SB
a
a
r
- 23 -