Текст страницы
•• Installing the M.2 rubber pad (applicable only for M.2 connectors without pre-installed thermal
pads):
a. When using a double-sided M.2 SSD, attach the thick rubber pad to the recommended placement
area as shown below.
b. When using a single-sided M.2 SSD, first stick the thin rubber pad to the thick rubber pad, and then
attach them to the recommended placement area as shown below.
Thin Rubber Pad (Gray)
Recommended Pad Placement
Area
Thick Rubber Pad (Black)
80
Avoid contacting any chips or IC components on the motherboard when attaching the rubber pads.
•• M2B_CPU:
Step 1: Turn the M.2 EZ-Latch Click clip on the M2Q_SB connector clockwise and remove the
motherboard heatsink.
Step 2: Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2
SSD and make sure the M.2 SSD is secured by the clip.
Step 3: Remove the protective film from the bottom of the motherboard heatsink, and finally, turn the
M.2 EZ-Latch Click clip clockwise and then install the heatsink back in place.
•• M2Q_SB:
Step 1: Turn the M.2 EZ-Latch Click clip clockwise and remove the motherboard heatsink.
If you want install an M.2 SSD in the 110mm hole, remove the EZ-Latch Plus clip from the
80mm hole first.
Step 2: Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2
SSD and make sure the M.2 SSD is secured by the clip.
Step 3: Remove the protective film from the bottom of the motherboard heatsink, and finally, turn the
M.2 EZ-Latch Click clip clockwise and then install the heatsink back in place.
* Types of M.2 SSDs supported by each M.2 connector:
M.2 PCIe x4 SSD
M.2 PCIe x2 SSD
M.2 SATA SSD
M2A_CPU
a
a
r
M2B_CPU
a
a
r
M2Q_SB
a
a
r
&
&
Please visit GIGABYTE's website for details on using M.2 EZ-Latch Click/M.2 EZ-Latch Plus.
M.2 SSD installation with M.2 EZ-Latch Click: https://www.gigabyte.com/WebPage/1048/M.2-EZ-Latch-Click.html
M.2 SSD installation/removal with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/1098/M2-latchplus-simple.html
* Motherboard heatsink design may vary by model.
- 26 -