Текст страницы
C9 Drying
Part
Maintenance
Frequency
Replacement
Frequency
debris on the filter. If the filter is very
dirty, rinse it with cold water and
shake off the remaining water.
D1-2—Dry all the parts thoroughly before
Charging
contacts
As needed
N/A
reinstalling them back in place.
When self-cleaning is completed, drying will
start automatically. During charging, press
and hold the
button for 2 seconds to
switch the drying mode. Press and hold the
Clean tank
2-4 weeks
N/A
Notes:
button for 2 seconds to start/stop drying.
• Allow at least 24 hours for the filter to dry thoroughly
Notes:
Notes:
• The frequency of replacement may vary with the
• Drying will automatically start after self-cleaning
before reinstalling it.
• Do not touch the filter surface with hands, brushes, or
sharp objects to avoid damaging it.
completes. Do not often start drying manually.
• Self-cleaning and drying are available only when the
actual situation. If abnormal wear occurs, replace the
parts immediately.
• The vacuum cleaner must be powered off or stopped
D2 Clean Tank and Roller
running, and the charging dock unplugged before you
clean or maintain them.
D2-1—Grip the clean tank handle, press the
Product Maintenance
vacuum cleaner is being charged and with a high
battery level. Different drying modes require different
power levels. When the vacuum cleaner is set to
Fast Drying mode but the battery level is low, it will
automatically switch to Quiet Drying mode.
• Stay away from the drying air outlets during drying.
release button, and gently pull the
clean tank upwards at a slight angle
to uninstall the tank.
D2-2—Rinse the tank bottom with clean water.
Routine Maintenance
D
D2-3—Grab the roller release tab and pull
If this product is left unused for a prolonged
period of time, fully charge it, unplug it,
and store it in a cool and dry place. Do not
place it in humid locations or direct sunlight.
Charge it at least once every 3 months to
avoid battery overdischarge.
To maintain optimal performance of the
vacuum cleaner, refer to the following table
for routine maintenance.
the roller out along the cleaner head.
Use the provided maintenance brush
to remove the dirt on the roller, then
rinse it with clean water.
Vacuum Cleaner
Part
Maintenance
Frequency
Replacement
Frequency
D2-4—When you need to replace the roller,
Roller
2-4 weeks
6-12 months
Filter
1 month
6-12 months
Wipe and clean the vacuum cleaner with a
soft, dry cloth. Before cleaning, remove the
vacuum cleaner from the charging dock and
power it off.
pull the roller cap out of the roller by
grabbing the whole cap. Then, install
the roller cap to a new roller.
Notes:
As needed
N/A
D1 Dirty Tank and Filter
Cleaner head
and dirty water
pathway
- Use the maintenance brush carefully to avoid injury.
- When you detach the roller cap, do not pull it by its
D1-1—Uninstall the dirty tank, pull out the
Dirty tank
As needed
N/A
handle.
• To prevent potential damage, keep the roller cap
attached while cleaning the roller.
Charging dock As needed
N/A
D2-5—Reinstall the roller and clean tank.
tank cover, and remove the filter on
the tank cover. Use the provided
maintenance brush to clean the
24
24