Текст страницы
will reduce the moisture
removal rate. This model is
designed to operate at
temperatures above
5≦(41≦).
The area is too large
Appliance runs
too long
The capacity of the
appliance can not meet the
area of the room
Doors and windows are
open
Close the door and window
Frost appears on
heat-exchanger
It is normal, frost usually
disappear in 60 min
Appliance run recently
or the room
temperature is too low
Fan noise
The air is passing
through the appliance
This is normal
The drain connection
may be aging or loose
Check the drain connection
and the appliance is placed
level
Water on the
floor
The drain pipe is
connected, but the
water is not drained.
If use the bucket, remove
the drain pipe and put back
the drain cover; or install
the drain pipe correctly
If the following error code appears, please check the causes and solution.
Code
Description
Possible Causes
Solutions
EH
Humidity
sensor failure
Humidity sensor is
damaged.
Connect customer
service center.
E1
Temperature
sensor failure
Temperature sensor is
damaged.
Connect customer
service center.
E2
Ambient temperature is
too high.
Move the appliance
to cooler place.
E3
Gas leakage
E3 appears many times.
Connect customer
service center.
NOTE:
1.If E3 appears, please the check the ambient temperature range
whether below 32 ≦.
If the ambient temperature over 32 ≦, place the unit into the place below
32 ≦ (suggest 30≦) for two hours before running the appliance again.
Star-up the unit, if the E3 appears again, please contact the service center.
Strictest operation environment: 5≦~32≦（41≦~90≦）,30%RH~90%RH