Текст страницы
- APPLIANCE DESCRIPTION
- Handle
- Water tank
- Ceramic sole
- Water inlet opening
- Protective cover for the sole
- Operation indicators
- On/off button
- Steam supply button
ADDING WATER
1. Remove the water tank (2) from the appliance by holding it with your fingers
on both sides.
2. Open the water inlet (4) and add water. Make sure that the liquid level does
not exceed the «MAX» mark.
3. Install the water tank back into the appliance, press it firmly, wipe the outside
surface, and be sure to drain the remaining water after use is complete.
4. It is recommended to use tap water without impurities and oils. In the case of
hard water, it is recommended to boil it beforehand, allow it to cool, filter it, or
use distilled water. Avoid using water treated with chemical cleaning agents.
Operation indicator
Weak steam supply
Average steam supply
Strong steam supply
Dry ironing
Water absence
indicator
Auto-cleaning
Auto-shutdown
19. Do not use the appliance if:
-
the power cable is damaged;
-
the appliance has visible damage;
-
the appliance has been dropped or exposed to moisture.
20. Do not operate the appliance at temperatures below 0 °С and above 35
°С. If the appliance has been exposed to temperatures below 0 °С for a
prolonged time, place it in a heated environment for at least 3 hours before
turning it on.
21. The surface of the heating element remains hot for some time after the
unit is turned off.
22. The accessible surfaces of the appliance can become hot during operation.
23. Pull the plug from the power socket if: the appliance does not work
correctly (unusual noise, vibration, etc.); before disassembly/reassembly;
after each use.
24. Disconnect the appliance from power supply if You have to leave it
unattended for even a short time.
25. Special instructions for transportation (shipment) and sale: none.
26. Packaging materials can be potentially hazardous to children and should
be stowed away in a specially designated place.
27. Should You decide to transfer the appliance to another person, please pass
the present manual over along with it.
USING THE DEVICE
1. Connect the appliance to the mains by plugging it into an outlet with the
specified voltage. Press the on/off button (7), the operation indicator
will
light up, and the dry ironing indicator
will flash, and the appliance will
start preheating. Wait until the indicator
stops flashing, which means that
the heating is completed, and the appliance is ready for use in dry ironing
mode (after about 30 seconds).
2. Make sure that there is enough water in the tank. If not, add water to the
tank according to the previous section. Disconnect the appliance from the
mains first.
3. To activate the steam ironing function, press the steam supply button (8).
4. With each double press, the modes will switch:
- COMPLETENESS
- Steamer assembly - 1 pc.
- Protective cover - 1 pc.
- User Manual - 1 pc.
(weak steam supply)
(medium steam supply)
(strong steam supply). As soon as steam comes out of the steam nozzles, the
device is ready for use in steaming mode.
ATTENTION!
- Be careful when operating the appliance as hot steam is discharged!
- Disconnect the appliance from power supply during filling with water and
cleaning.
- Take precautions when using the device due to the release of steam.
Disconnect the appliance from the power supply during filling and cleaning.
ATTENTION! A single press on the steam supply switch turns off the steam supply,
and it does not matter which steam supply mode (weak, medium or strong) the
device is currently in.
4. OPERATING PROCEDURE
- Remove the protective cover and stickers from the working surface of the
steamer. Unwind and straighten the power cable.
- When using the steamer for the first time, release a small amount of steam
into the air. This will help to get rid of the impurities and perfumes obtained
by the device during the production process.
15