Текст страницы
1. Fill the device’s tank with a solution of water with vinegar (6-9%) in a ratio of
3:1. Turn on the steamer in steaming mode and wait 5 minutes, then turn off
the steamer and pour the remaining solution out of the tank.
2. After that, fill the tank with clean water and repeat the procedure.
5. To turn off the device, press the button (7) again.
6. If the water level in the tank drops below the minimum in steaming mode, the
no water indicator
will start flashing, and a beep will sound to indicate
that the water needs to be refilled.
7. If the device is not used for more than 15 minutes, the «Auto-off» function
is triggered: The indicator
flashes several times, after which the device
turns off.
8. In standby and cooling mode, the steamer can be placed either on a heat-
resistant surface or on a protective cover included in the kit.
- TECHNICAL SPECIFICATIONS
- Rated voltage: 220-240 V ~50/60 Hz
- Rated power: 1800-2100 W
- Steam supply: 1 mode - 15 g/min, 2 mode - 22 g/min, 3 mode - 45 g/min.
- Ready-to-use time: 30 seconds
- Duration of continuous steam supply: 6 min.
- Volume: 200 ml
AUTO-CLEANING
In the off state, press and hold the steam supply button (8) for 10 seconds, and
the automatic self-cleaning of the appliance will begin. The indicator
will
light up on the display.
CAREFUL: accessible surfaces of the appliance can reach high
temperature during operation. Do not touch the hot surfaces.
ATTENTION! It is not possible to interrupt the self-cleaning function before it
finishes. Be careful, there is a risk of burns! It is recommended to carry out
auto-cleaning of the device once every 2 weeks with regular use.
7. DISPOSAL
Upon expiry of its service life the appliance can be disposed of separately from
ordinary domestic waste. You can turn it over to a specialized electric and
electronic appliance disposal and recycling centre.
TIPS AND TRICKS
- When steaming the bottom of the garment, use a hanger to maximize fabric
tension. To do this, you need to fasten all the buttons (if any) on your clothes
and pull the lower part of the clothes hanging on the hanger slightly to the
side with your free hand, creating tension.
- With the steamer, you can perform vertical ironing of the curtains without
removing them from the curtain rod. It is enough to place the steam iron at
a small distance from the surface of the fabric and carry out the standard
steaming procedure. It should be noted that, depending on the density of the
fabric from which the curtains are sewn, steam will penetrate through the
fabric in different volumes. A certain amount of steam can settle on the surface
of the windows if the curtains are too close to them.
- To smooth out the heavily wrinkled material, steam it on both sides.
- If the wrinkles are difficult to smooth out, for example, due to the fact that the
fabric has been over-dried, we recommend that you spray it with water first.
Repeated steaming may be required to smooth out dense fabrics.
- Do not use metal hangers or hangers, as they may rust from exposure to steam.
- After steaming, the fabric may be slightly damp, so do not immediately put
the item away for storage, but dry it by hanging it on a hanger or spreading
it out on some surface.
- Take special care when steaming delicate fabrics and those fabrics that may
be damaged by water splashing.
ATTENTION! The device is designed for vertical steaming. Avoid steaming things
in a horizontal position.
5. CLEANING AND MAINTENANCE OF THE DEVICE
Wipe the steamer body with a damp cloth. Periodically flush the water tank.
Do not allow water to stagnate in the tank, as this can lead to water blooming
and precipitation.
- Take the steamer in one hand, hold the lower part of the clothes with the other,
creating a slight tension. Bring the iron to the surface of the fabric, pressing
the work surface slightly against it, and start steaming with reciprocating
movements (from top to bottom). We recommend starting with the areas with
the most wrinkles, as well as with the elements of clothing that are more
dense (collar, sleeve cuffs).
DESCALING
With regular use of the steamer, it is recommended to remove the scale
at least twice a year.
8. CERTIFICATION DATA, GUARANTEE
The service life of this item is 5 years since the date of sale to the end user,
provided the item will be used in strict accordance with the present manual and
the applicable technical standards. Upon expiry of the service life please contact
the nearest authorized service centre for suggestions as to further operation
of the appliance. The manufacturing date of the appliance is integrated into the
serial number (digits 2 and 3 - year, digits 4 and 5 - month of manufacture). If any
questions related to appliance maintenance should arise, or if the appliance has
malfunctions, apply to the CENTEK TM Authorized Service Center. The address of
the service center can be found on the website https://centek.ru/servis. Service
16