Текст страницы
6
EN
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Clean the steam station body (1) and the iron
soleplate (5) with a slightly damp cloth, then wipe it
dry.
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or
similar qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after the unit was dropped, unplug it
and apply to the service center.
• To avoid damages, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
WATER SELECTION
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
• Use tap water to fill the water tank (2).
• We recommend to fill the tank (2) with water
additionaly cleaned with domestic filters.
• If tap water is hard, it is recommended to mix it with
distilled water in proportion 1:1. If tap water is too
hard, mix it with distilled water in proportion 1:2 or
use distilled water only.
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using.
FILLING THE WATER TANK
ATTENTION! Before filling the water tank (2) with water
make sure that the iron is switched off and unplugged.
• Take the handle (3) and remove the water tank (2).
• Fill the tank (2) with water through the water inlet
(15), install the tank (2) back to its place and make
sure that the tank (2) is installed properly.
• Unpack the steam station and remove any packaging
materials and advertising stickers.
• If there is a protective film on the soleplate (5),
remove it.
• There may be water residue in the tank (2), as the
steam station has undergone factory quality control.
• Keep the original package.
• Read the safety measures and operating
recommendations.