Текст страницы
8
EN
• During the operation hold the iron by the handle (8).
• To switch the steam supply on, press the steam
supply button (6) «
», for constant steam supply,
press and hold the button (6), to switch the steam
supply off, release the button (6).
• Before starting work, you need to release some
steam, because condensate may accumulate in the
steam pipe (9), to do this, press the steam supply
button (6) «
», directing the steam, for example,
onto a kitchen towel, drops of water and steam will
come out of the holes of the iron soleplate (5).
Notes:
• You can iron woolen clothes on the right side, but it is
recommended to use a damp gauze or ironing net.
• Install the steam station on a flat, stable, heat and
moisture resistant surface so that the device is at
the same level with your ironing board, if you put the
steam station on an ironing board, make sure that the
ironing board is secure and stable.
• Steam ironing is possible only if the temperature
control knob (7) is set to the steam mode «••», «•••» ,
«MAX» or «SHOT».
Note: if you have set the ironing temperature to
«SHOT», after pressing the steam button (6) once, the
light indicator (12) will flash, wait until the light indicator
(12) glows constantly and press the steam button (6)
again.
-
when the unit is switched on for the first time a
foreign smell can appear - it is normal and is not
covered by warranty;
-
each time you press the steam supply button (6)
«
», the pump is switched on, the operation of
which is accompanied by a characteristic sound;
-
when the water tank (2) is empty, the sound of the
pump will be much louder, switch the unit off by
pressing the on/off button (14) «
», unplug the
power plug (10), remove the tank (2) and pour
water into it, install the tank (2) back to its place,
switch the unit on and continue working;
-
during operation, the steam pressure may
change slightly, since with prolonged vaporization
the water temperature in the steam chamber
• Place the iron on the steam station body (1) in the
iron installation place (4).
• Insert the power plug (10) into a mains socket.
• Make sure that there is enough water in the water
tank (2).
• Turn the knob (7) to set the required ironing
temperature in the steam operation zone «••», «•••»,
«MAX» or «SHOT».
• Switch the iron on by pressing the on/off button (14) «
», the iron will switch on and the light indicator (12)
will start flashing.
• Once the soleplate (5) temperature reaches the set
one, the indicator (12) will glow constantly, you can
start ironing.