Текст страницы
3. Push the open end of the accessory onto the spot-
light nozzle.
Illustration I
Disconnecting accessories
1. Set the selector switch for the steam volume to the
rear.
The steam lever is locked.
2. Push the unlocking button and pull the parts apart.
Illustration J
Operation
Topping up the water
If the steam volume is reduced during work or if no more
steam volume comes out, the water will have to be re-
filled.
1. Switch the appliance off, see Chapter Switch off the
appliance.
2. Unscrew the safety lock.
3. Fill a maximum of 1 l distilled water or tap water into
the steam boiler.
4. Insert the safety lock.
5. Insert the mains plug into a socket.
6. Wait until the orange indicator light - heating goes out.
The appliance is ready for use.
Switch off the appliance
1. Pull the mains plug out of the socket.
2. Press the steam lever until no more steam flows out.
Illustration K
The steam boiler is depressurised.
3. Set the child lock (selector switch for steam volume)
to the rear.
The steam lever is locked.
Filling water
Note
Warm water reduces the heating-up time.
Note
Descaling the steam boiler is not required if commer-
cially available distilled water is used.
1. Unscrew the safety lock.
Illustration C
2. Drain the water completely out of the steam boiler.
Illustration L
3. Fill a maximum of 1 l distilled water or tap water into
the steam boiler.
Illustration C
4. Insert the safety lock.
Illustration D
Rinsing out the steam boiler
Rinse the appliance’s steam boiler after max. every
tenth boiler fill.
1. Switch the appliance off, see Chapter Switch off the
applianceSwitch off the appliance.
2. Allow the appliance to cool down.
3. Disconnect the accessory.
4. Fill the steam boiler with water and swing it around
vigorously. Lime residue which has been deposited
on the bottom of the steam boiler will be released as
a result.
5. Drain the water completely out of the steam boiler.
Illustration L
Switch on the device
1. Place the device on a firm surface.
2. Insert the mains plug into a socket.
Illustration E
The green and orange indicator lights illuminate.
3. Wait until the orange indicator light - heating goes
out.
Illustration F
4. Press the steam lever.
Illustration G
Steam leaks out.
Storing the device
1. Store the device in a dry location that is protected
from frost.
ATTENTION
Material damage due to a stuck safety lock
If the safety lock is not removed after cleaning, there is
a possibility that the lock could get stuck in the thread.
After cleaning, unscrew the safety lock and store it, for
example, with the other device accessories.
Regulating the steam volume
Note
The device heating always switches on again during
use to maintain the pressure in the steam boiler. The or-
ange indicator light - heating illuminates to indicate this.
The expelled steam volume is regulated using the se-
lector switch for steam volume. The selector switch has
3 positions:
Important application instructions
Maximum steam volume
Reduced steam volume
Freshening up textiles
Prior to using the appliance, always check the compati-
bility of the textiles at a concealed point: Steam down
the textile, allow it to dry and then check it for any
change in colour or shape.
No steam - child lock
Note
In this position, the steam lever cannot
be operated.
1. Set the selector switch for the steam volume to re-
quired steam volume.
2. Press the steam lever.
3. Before starting cleaning, point the steam gun at a
cloth until steam is expelled evenly.
Cleaning coated or painted surfaces
ATTENTION
Damaged surfaces
Steam can loosen wax, furniture polish, plastic coatings
or paint and edge band from edges.
Do not direct the steam at glued laminated edges as the
edge band may loosen.
Do not use the appliance for cleaning unsealed wood or
parquet floors.
Do not use the appliance for cleaning painted or plastic
coated surfaces such as kitchen or living room furniture,
doors or parquet.
1. To clean these surfaces, steam a cloth briefly and
use it to wipe over the surfaces.
English
19