Текст страницы
Using dust cup set
Optional accessory
NOTICE: Clean the dust and dirt on the tool
before installing the wireless unit. Dust or dirt
may cause malfunction if it comes into the slot of the
wireless unit.
Fit the dust cup set against the ceiling when operating
the tool.
► Fig.47
NOTICE: To prevent the malfunction caused by
static, touch a static discharging material, such
as a metal part of the tool, before picking up the
wireless unit.
NOTICE: Do not use the dust cup set when drill-
ing in metal or similar. It may damage the dust
cup set due to the heat produced by small metal
dust or similar.
NOTICE: When installing the wireless unit,
always be sure that the wireless unit is inserted
in the correct direction and the lid is completely
closed.
NOTICE: Do not install or remove the dust cup
set with the drill bit installed in the tool. It may
damage the dust cup set and cause dust leak.
1.
Open the lid on the tool as shown in the figure.
► Fig.50: 1. Lid
2.
Insert the wireless unit to the slot and then close
the lid.
NOTE: When using the bellows for chiselling, adjust
the length by expanding and contracting the bellows
according to the length of the bit.
► Fig.48: 1. Bellows for chiselling
When inserting the wireless unit, align the projections
with the recessed portions on the slot.
► Fig.51: 1. Wireless unit 2. Projection 3. Lid
4. Recessed portion
WIRELESS ACTIVATION FUNCTION
When removing the wireless unit, open the lid slowly.
The hooks on the back of the lid will lift the wireless unit
as you pull up the lid.
► Fig.52: 1. Wireless unit 2. Hook 3. Lid
Optional accessory
After removing the wireless unit, keep it in the supplied
case or a static-free container.
What you can do with the wireless
activation function
NOTICE: Always use the hooks on the back of
the lid when removing the wireless unit. If the
hooks do not catch the wireless unit, close the lid
completely and open it slowly again.
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
► Fig.49
Tool registration for the vacuum
cleaner
NOTE: A Makita vacuum cleaner supporting the
wireless activation function is required for the tool
registration.
To use the wireless activation function, prepare follow-
ing items:
•
A wireless unit (optional accessory)
•
A vacuum cleaner which supports the wireless
activation function
NOTE: Finish installing the wireless unit to the tool
before starting the tool registration.
The overview of the wireless activation function
setting is as follows. Refer to each section for detail
procedures.
NOTE: During the tool registration, do not pull the
switch trigger or turn on the power switch on the
vacuum cleaner.
1.
Installing the wireless unit
2.
Tool registration for the vacuum cleaner
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
3.
Starting the wireless activation function
Installing the wireless unit
If you wish to activate the vacuum cleaner along with
the switch operation of the tool, finish the tool registra-
tion beforehand.
Optional accessory
1.
Install the batteries to the vacuum cleaner and the
tool.
CAUTION: Place the tool on a flat and stable
surface when installing the wireless unit.
2.
Set the stand-by switch on the vacuum cleaner to
"AUTO".
► Fig.53: 1. Stand-by switch
3.
Press the wireless activation button on the vac-
uum cleaner for 3 seconds until the wireless activation
lamp blinks in green. And then press the wireless acti-
vation button on the tool in the same way.
► Fig.54: 1. Wireless activation button 2. Wireless
activation lamp
21
ENGLISH