Текст страницы
If the vacuum cleaner and the tool are linked success-
fully, the wireless activation lamps will light up in green
for 2 seconds and start blinking in blue.
3.
Set the stand-by switch on the vacuum cleaner to
"AUTO".
► Fig.56: 1. Stand-by switch
4.
Push the wireless activation button on the tool
briefly. The wireless activation lamp will blink in blue.
► Fig.57: 1. Wireless activation button 2. Wireless
activation lamp
NOTE: The wireless activation lamps finish blinking
in green after 20 seconds elapsed. Press the wireless
activation button on the tool while the wireless acti-
vation lamp on the cleaner is blinking. If the wireless
activation lamp does not blink in green, push the wire-
less activation button briefly and hold it down again.
5.
Turn on the tool. Check if the vacuum cleaner runs
while the tool is operating.
To stop the wireless activation of the vacuum cleaner,
push the wireless activation button on the tool.
NOTE: When performing two or more tool registra-
tions for one vacuum cleaner, finish the tool registra-
tion one by one.
Starting the wireless activation
function
NOTE: The wireless activation lamp on the tool will
stop blinking in blue when there is no operation for
2 hours. In this case, set the stand-by switch on the
vacuum cleaner to "AUTO" and push the wireless
activation button on the tool again.
NOTE: Finish the tool registration for the vacuum
cleaner prior to the wireless activation.
NOTE: The vacuum cleaner starts/stops with a delay.
There is a time lag when the vacuum cleaner detects
a switch operation of the tool.
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
NOTE: The transmission distance of the wireless unit
may vary depending on the location and surrounding
circumstances.
After registering a tool to the vacuum cleaner, the vac-
uum cleaner will automatically run along with the switch
operation of the tool.
1.
Install the wireless unit to the tool.
NOTE: When two or more tools are registered to
one vacuum cleaner, the vacuum cleaner may start
running even if you do not turn on your tool because
another user is using the wireless activation function.
2.
Connect the hose of the vacuum cleaner with the
tool.
► Fig.55
Description of the wireless activation lamp status
► Fig.58: 1. Wireless activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the table below for the
meaning of the lamp status.
Status
Wireless activation lamp
Description
Color
On
Blinking
Duration
Standby
Blue
2 hours
The wireless activation of the vacuum cleaner is available. The
lamp will automatically turn off when no operation is performed
for 2 hours.
The wireless activation of the vacuum cleaner is available and the
tool is running.
When
the tool is
running.
Tool
registration
Green
20 seconds
Ready for the tool registration. Waiting for the registration by the
vacuum cleaner.
2 seconds
The tool registration has been finished. The wireless activation
lamp will start blinking in blue.
Red
20 seconds
Ready for the cancellation of the tool registration. Waiting for the
cancellation by the vacuum cleaner.
Cancelling
tool
registration
2 seconds
The cancellation of the tool registration has been finished. The
wireless activation lamp will start blinking in blue.
Others
Red
3 seconds
The power is supplied to the wireless unit and the wireless activa-
tion function is starting up.
Off
-
-
The wireless activation of the vacuum cleaner is stopped.
tool.
Cancelling tool registration for the
vacuum cleaner
2.
Set the stand-by switch on the vacuum cleaner to
"AUTO".
► Fig.59: 1. Stand-by switch
Perform the following procedure when cancelling the
tool registration for the vacuum cleaner.
3.
Press the wireless activation button on the vac-
uum cleaner for 6 seconds. The wireless activation
1.
Install the batteries to the vacuum cleaner and the
22
ENGLISH