Текст страницы
EN
MANUAL
27
4 SAFETY REQUIREMENTS
4 SAFETY REQUIREMENTS
4.11 When working with the product, it is
recommended to wear suitable clothing so
that no parts come into contact with the
product and the workpiece/material being
processed. Also make sure that you wear
nothing that could interfere with your work
or cause undesirable consequences.
4.12 When working, hold the device firmly.
4.13 Always place the product on a special
stand when you are not using it.
4.14 Do not leave the product switched on
or connected to a power source without
attention.
4.15 Avoid the power cord hitting the
product or material to be processed or
foreign objects that could damage it.
4.16 Keep the power cord away from heat
source, oil and sharp objects.
4.17 During the operation of the product,
do not touch any grounded objects (for
example, pipes, radiators, gas stoves,
refrigerator).
4.18 When disconnecting the product from
the power supply, hold the plug of the
power cord firmly.
4.19 Always disconnect the product from
the power supply when you are not using
it before performing any maintenance or
servicing, or:
- in case of problems;
- before installing/changing the sanding
paper;
- before cleaning;
-
before
mounting/dismounting
the
additional handle (if available);
- after the completion of the work.
4.20 Do not use the product after it has
fallen off or if damaged or damaged power
cords or plugs are visible on it. To diagnose
or repair the product, contact an authorized
service center.
4.21 If the power cord is damaged, it
must be replaced by the manufacturer,
his representative or a similar qualified
person to avoid danger. The power cord is
replaced by an authorized service center in
accordance with the applicable tariff.
The safe and stable operation of the
product is guaranteed only if the
following conditions are met:
4.1 Do not use the product for any purpose
other than those specified in this operating
manual. The operation, maintenance and
storage of the product must be carried out
strictly in accordance with these operating
instructions.
4.2 The product is not intended for use by
persons (including children) with reduced
physical, sensory or mental abilities or lack
of life experience or knowledge, unless
they are supervised or instructed to use
the product by a person responsible for
their safety. Children should be supervised
to avoid playing with the product. Do not
allow animals to come into contact with the
product. Do not allow children, animals or
strangers in the work area.
4.3 Do not allow children to come into
contact with the product, even if it is turned
off and disconnected from the power
supply.
4.4 Do not immerse the product or its
individual parts in water or other liquids.
4.5 Do not use the product if there is a
risk of fire or explosion, for example, near
flammable liquids and gases.
4.6 Carry the power tool by holding it only
by the handle (or by the base), while it is
forbidden to hold your finger on the switch.
4.7 Do not carry the power tool when it is
switched on.
4.8 Before starting work, make sure that
the power supply parameters meet the
requirements specified on the product and
in this operating manual.
4.9 Connect the product to the power
supply only after you make sure that the
necessary nozzles are installed correctly
and all the elements are ready for welding.
4.10 Use personal protective equipment
when
working
with
the
product.
If
necessary, use a respirator, special gloves,
glasses and headphones.