Текст страницы
EN
MANUAL
28
4.22 Operation and maintenance must
be carried out regularly and strictly in
accordance with these instructions. During
maintenance, do not use detergents
that could damage the product or power
cords (gasoline and other aggressive
substances).
4.23 Improper handling of the Product may
cause malfunctions, damage to the user or
his property.
dust and small particles do not fly in your
direction
It is FORBIDDEN to touch the working
surface of power tool until it is stopped and
completely cooled.
In order to avoid overheating of the power
tool, you should take sufficient breaks in
work to ensure cooling.
The tool is intended ONLY for dry work. Do
not use this product when working with wet
surfaces, in damp rooms or in rain/snow to
avoid electric shock.
Keep your hands outside the area to be
treated to avoid injury from contact with the
working nozzle.
It is FORBIDDEN to use the product in a
state of alcoholic or narcotic intoxication,
as well as in other conditions that interfere
with the objective perception of reality, and
you should not trust the product to people
in such a state or in such conditions!
5 WORKING PROCEDURE
5 WORKING PROCEDURE
ATTENTION! This user manual can
not give advice for all sorts of unusual
situations that may arise during the
operation of this product. The user must
independently take safety measures when
working with the product!
5.1
Store
the
product
at
ambient
temperatures from 0°C to +40°C and a
relative humidity of no more than 80% in a
place inaccessible to children and animals.
5.2 Transport the product only in the
original packaging to avoid damage. After
transportation or storage of the product at
a low temperature it is necessary to keep it
at room temperature for at least two hours.
5.3 When transporting, loading, unloading
and storing the product, in addition to the
requirements described in the operating
instructions, the following guidelines must
be observed:
- do not expose the product to significant
mechanical loads that may damage the
product and /or affect the integrity of the
packaging;
- it is necessary to avoid getting water
and other liquids on the packaging of the
product.
5.4 Before transport or transfer to storage
at a negative temperature in use, it must
be ensured that there is no water in the
product. All surfaces the products must be
dry.
5.5 Keep the product away from significant
temperature
fluctuations
and
direct
sunlight.
PRECAUTIONS FOR WORKING WITH
THE POWER TOOL
Before using the product for the first time,
turn it on without load and leave it on
for a few minutes. If during this time you
feel excessive heat or a strong foreign
smell, turn off the product, disconnect the
power cord from the mains and contact an
authorized service center for diagnostics
and repair of the product.
It
is
FORBIDDEN
to
install
other
consumables on the product that are not
provided for in the design or approved by
the manufacturer, or do not use adapters
for installation.
When the power tool is switched on, move
it towards the surface to be machined.
Do not press too hard on the power tool
during operation.
Do not put down the power tool
immediately after switching off, wait until
the motor is completely stopped.
Always try to hold the power tool so that