Текст страницы
Cordless Planer
cutting edges become blunt, the planer blade
needs to be changed. The HM/TC planer
blade must not be resharpened.
Removing the planer blade (see
figure A)
To turn or replace the planer blade, turn the
blade head until it is parallel to the planer
base plate.
►Loosen the two fastening screws using the
hex key (approx. 1–2 turns).
►If necessary, loosen the clamping element
by
►lightly striking it with an appropriate imple
(2) Knob for setting the cutting depth (insulated
gripping surface)
(3) Chip ejector
(4) Power button lock
(5) Power button
(6) V-groove
(7) base plate
(8) Handle (insulated gripping surface)
(9) Drum
(10) Clamping element for planer blade
(11) Fastening screw for planer blade
(12) Planer blade
(13) Open-end wrench
(14) Chip/dust bag
(15) Quarter sampling depth limiter
(16) Parallel stop
Technical parameter
Model
PEP20H-82A
Rated voltage
DC20 V
Rated output power
20v
Rated speed
16000 r/min
Planing width
82 mm
Max.Planing depth
2mm
Weight
2.7 kg
Contents of delivery
Electric planer 1pc
Wrench 1pc
Fastener kit 1set
Quarter depth stop 1pc
Hex key 1pc
Dust bag 1pc
User manual 1pc
Note
Since the product is constantly being
improved, P.I.T. reserves the right to make
changes to the specifications and product
specifications specified here without prior
notice.
The text and numbers of the instructions may
contain technical errors and typographical er
rors.
Fitting
►Pull the plug out of the socket before
ment, e.g. a wooden wedge.
Fitting the planer blade (see figure
B)
The guide groove on the planer blade ensures
a constant,even height setting when changing
or turning the blade.
If necessary, clean the knife seat in the clamp
ing element and the planer blade.
When fitting the planer blade, ensure that it is
correctly seated in the mounting guide of the
clamping element.
The planer blade must be fitted and aligned
with the centre of the planer base plate.
Then tighten the two fastening screws with
the hex key.
Note: Check that the fastening screws are
firmly tightened before starting operation. Turn
the blade head by hand and ensure that the
planer blade is not brushing against anything.
Dust/Chip Extraction
The dust from materials such as lead paint,
some types of wood, minerals and metal can
be harmful to human health.
Touching or breathing in this dust can trigger
allergic reactions and/or cause respiratory
illnesses in the user or in people in the near
vicinity.
Certain dusts, such as oak or beech dust,
are classified as carcinogenic, especially in
conjunction with wood treatment additives
(chromate, wood preservative). Materials con
taining asbestos may only be machined by
specialists.
carrying out any work on the power
tool.
Changing the Tool
►Take care when changing the planer
-
Use a dust extraction system that is suit
able for the material wherever possible.
-
Provide good ventilation at the workplace.
-
It is advisable to wear a P2 filter class
breathing mask.
The regulations on the material being ma
chined that apply in the country of use must
be observed.
blade. Do not pick up the planer blade
by the cutting edges. You may be injured
by the sharp cutting edges.
Use only original P.I.T HM/TC planer blades.
The hard metal (HM/TC) planer blade has
two cutting edges and can be turned. If both
6