Текст страницы
USING
7.5
TURNING THE PROJECTOR ON
1.
Securely connect the mains cable to the projector and to a mains outlet. When connected, the Power LED will
turn red.
2.
Connect a signal/source cable to a source device and the projector.
3.
Remove the lens cap.
4.
Press the Power V2.0 02/2025 on the keypad or the
symbol on the remote control.
The InFocus startup screen will appear after approximately 10 seconds. The Power LED will flash blue and then
steady blue.
ATTENTION
Make sure that people cannot step on any electrical cables or trip over the cables. Do not put objects
on the cables.
7.6
SELECTING A INPUT SOURCE
1.
Turn on the connected source, such as a computer or DVD player, or connect a digital media player, such as a
Google Chromecast.
2.
Press the Source button on the keypad or remote control to select the input source.
3.
Play the content on the source device.
INFORMATION
You can set up the projector to automatically detect an active source and turn itself on and project the
source content automatically. To turn on this feature, press the Menu button on the remote control or
keypad, navigate to Settings › Power Settings › Signal Power, and select On.
INFORMATION
Your projector has a Direct Power On setting. This setting will automatically turn on the projector when
a power source is connected. To turn on this feature, press the Menu button on the remote control or
keypad, navigate to Settings › Power Settings › Direct Power On, and select on.
7.7
TURNING THE PROJECTOR TO STANDBY MODE
1.
Press the Power button on the keypad or remote control.
The following message will appear: Power Off?
2.
Press the Power button again to confirm turning off your projector.
If the Power button is not pressed a second time, the message will disappear after 10 seconds and the projector
will not turn off.
The cooling fans will operate for about 10 seconds and the Power LED will flash blue. When the Power LED
changes to solid red, the projector has entered standby mode.
3.
Replace the lens cap.
INFORMATION
If you want to turn the projector on again, wait 100 seconds.
Always allow the projector fan to turn off after you power down and before you unplug the projector power cable
from the electrical outlet.
[page 34] | infocus.com