Текст страницы
3 Use
3.1 Intended use
3.4 Attaching/removing the
parquet/carpet brush
1. Attach the parquet/carpet brush (12) to the
The appliance was designed to be used in houses,
and is not fit for industrial use.
telescopic pipe (14) in the direction of the
arrow.
3.2 Attaching/removing the
hose
1. To attach the hose (1) pull the hose cap (9) in
the direction of arrow until it is aligned with the
housing.
2. You can remove the telescopic pipe (14) from
the parquet/carpet brush (12) by pulling it.
3.5 Adjusting the parquet/
carpet brush
• The tabs on the hose cap (9) must be seated
By pressing the adjustment latch (13) located on
the parquet/carpet brush (12);
correctly.
• To vacuum on firm ground and parquet, extend
2. To remove the hose (1) press on the tabs on the
the brush before vacuuming.
hose cap (9) and pull it.
• To vacuum on carpets and rugs, retract the
brush before vacuuming.
3.3 Attaching/removing the
telescopic pipe
3.6 Operation
1. Attach the telescopic pipe (14) to the handle
(18).
1. Plug the appliance after pulling the power plug
located at the back of the appliance.
A
WARNING: Stop pulling the
appliancecable when it comes to the
yellow mark located on it. After the
yellow mark the red mark comes. Do
not pull any more after reaching the
red mark.
2. Pull the telescopic pipe (14) from the handle
2. Press on/off button (6) to switch on your
(18) to remove it.
3. Push the telescopic pipe adjustment latch (15)
appliance.
and pull the telescopic pipe (14) to adjust its
length.
Vacuum cleaner / User manual
7 / EN