Текст страницы
Problem
Possible reason
Solution
The dust bag/container is full
“Clean the dust bag/container and
filter”
Clean the appropriate filter. Check
The filters are dirty
Full dust bag/container indicator is on
out “Cleaning the dust
bag/container and filter”
Brush, telescopic tube or hose
Remove the obstacles. If
necessary, use, for example, a thin
is blocked
wooden stick
Turn off the vacuum cleaner and
unplug the power cord from the
outlet. Eliminate the cause of
overheating (e.g. by disassembling
the telescopic tube and hose and
The protection against
overheating has triggered
Vacuum cleaner stops suddenly
(possibly due to blocked
exhaust ducts, filters, full dust
bag/container, etc.)
removing obstacles and/or
cleaning the filters and dust
bag/container. Wait about 40
minutes until the vacuum cleaner
cools down. After the vacuum
cleaner has cooled down, you can
turn it on again.
Vacuum cleaner is not picking up dirt
A crack or a hole in the hose
Check the hose and replace if
necesarry.
ENGLISH
Cord rewinder is not fully rewound
The cord is twisted or unevenly
Pull out the power cord for 2-3
meters and press the cord rewind
rewound
button
The bypass valve is open
Close it
Suction power does not match
Adjust the position of the suction
the surface to be cleaned
power regulator
Changing and installing the brush.
Cleaning results are unsatisfactory
The brush / brush mode is not
despite the fact that the vacuum
suitable for cleaning surfaces
cleaner is working properly
Check out “Assembling the
vacuum cleaner and installing
accessories”. Adjust the brush
switch
The dust bag/container is full
“Clean the dust bag/container and
filter”
The filters are dirty
“Clean the dust bag/container and
filter”
Electrostatic discharge
Probably there is excessive dry
Reduce the suction power.
Ventilate the room or use a
air indoors
household air humidifier
59