Текст страницы
7
EN
USING THE ATTACHMENTS
Floor/carpet brush (1)
When using the brush (1) set the switch (2) to the
necessary «FLOOR/CARPET» position.
Crevice nozzle 2-in-1 (13)
upholstery brush (14) and connect it to the telescopic
extension pipe (4).
• Extend the lower part of the telescopic pipe (4) to the
required length, having preliminary pressed on the lock
(3).
• You can install the crevice nozzle 2-in-1 (13) and the
furniture upholstery brush (14) directly into the installation
place (5).
ATTENTION!
This attachment can be used as a dust removal brush
or as a crevice nozzle; to do this, place the brush in the
required position.
Furniture upholstery brush (14)
The brush (14) is intended for cleaning cloth furniture
upholstery.
Vacuum cleaner wall mount (15)
• Select a storage place for the vacuum cleaner.
• Position the wall mount (14) so as to prevent the
vacuum cleaner from hanging completely; the vacuum
cleaner should rest on the brush (1).
• Make sure that no electric wiring or other utilities is
inside the selected wall area before drilling orifices in it.
• Mark where the openings will be and drill them.
• Secure the wall mount (14) using dowels and mounting
screws.
• Do not use the vacuum cleaner in places where aerosols
are used or sprayed and in proximity to highly inflammable
liquids, do not use the vacuum cleaner in the places
where such liquids are stored.
• The vacuum cleaner is not intended for collecting water
or any other liquids; do not use it for collecting burning or
smoking cigarettes or cinders.
• Do not use the vacuum cleaner for collecting dust of
plaster, concrete, flour or ashes.
• Take sharp objects away from the floor before cleaning to
prevent damage to the unit.
• If the suction capacity of the vacuum cleaner suddenly
decreases during cleaning, immediately switch the
vacuum cleaner off and check the telescopic pipe (4)
for blockages, remove the blockage, and then you can
continue cleaning
ASSEMBLING THE VACUUM CLEANER
USING THE VACUUM CLEANER
The cyclonic filter and the separator (11) are installed in
the dust bin (8), which filter out debris and dust from the
• Insert the telescopic pipe (4) into the installation place
(5).
• Select the required attachment - the floor/carpet brush
(1), the crevice nozzle 2-in-1 (13) or the furniture