Текст страницы
8
EN
• Close the lid (12).
incoming air, and the HEPA filter (10) finally retains the
smallest dust particles.
Cleaning the separator (11) and the HEPA filter (10)
installed in the dust bin (8)
Note: always keep the HEPA filter (10) clean because the
performance of the vacuum cleaner depends on it.
Attention! Before switching the vacuum cleaner on
and using it, make sure that the HEPA filter (10) and the
separator (11) are installed properly.
• Unwind the power cord to its full length.
• Connect the power plug to an electrical outlet.
• Switch the unit on by setting the power switch (6) to the
position «I».
• After you finish cleaning, switch the vacuum cleaner off
with the power switch (6), disconnect the power plug
from the mains.
ATTENTION! Before changing the attachments or
cleaning the dust bin (8), switch the vacuum cleaner off
with the power switch (6), disconnect the power plug from
the mains.
CLEANING AND MAINTENANCE
Cleaning the dust bin (8)
• Preliminarily remove dust and garbage from the dust bin
(8) as described above.
• Turn the separator (11) counterclockwise and remove it
(fig. 2).
• Clean the separator (11) from dust and garbage.
• Turn the HEPA filter (10) counterclockwise and remove
it (fig. 3).
• Clean the HEPA filter (10) from dust and garbage.
• Wash the separator (11) and the HEPA filter (10) under a
warm water jet and dry them (fig. 4).
• Do not wash the parts in a dishwashing machine.
• Dry the separator (11) and the HEPA filter (10)
thoroughly.
• Do not dry the HEPA filter (10) with a hairdryer or similar
appliances.
• Wipe the inner surface of the dust bin (8) with a slightly
damp cloth.
• Insert the HEPA filter (10) into the dust bin (8) and turn it
clockwise until bumping.
• Insert the separator (11) into the dust bin (8) and turn it
clockwise until bumping.
• Close the lid (12) until the lock (9) clicks.
Attention! Before assembling the dust bin (8) make sure
that the separator (11) and the HEPA filter (10) are dry.
• It is recommended to remove garbage and dust from
the dust bin (8) after every room cleaning.
• Switch the vacuum cleaner off with the power switch (6)
and disconnect the power plug from the mains.
• Press on the lock (9) and open the lid (12) (fig. 1).
• Place the dust bin (8) over a garbage bin.
• Remove accumulated dust and garbage from dust bin
(8).